Main > Main Forum

Ipac 4 help

(1/3) > >>

Lon:
I have an IPAC4 and can not get the  functions from player 3 or 4 to work. I know the microswitches are good because I can switch the wire to a Player 1 input on the IPAC and it will work. But in IPD it will not recognize a button plugged into player 3 or 4 inputs. I have not emailed ANDY about this yet because of the time difference to UK. I was hoping someone could provide insight on to what I was overlooking.

Thanks,
Lon

Scott84:
you should email andy, hes a great guy!

Lon:

--- Quote from: Scott84 on March 06, 2006, 02:03:13 pm ---you should email andy, hes a great guy!



--- End quote ---

Yea I will if needed. I just thought I might get a faster response here due to the time difference.

My Ipaq 4 has 2 green lights. one for each Ipac2 , so I assume it is working, but I just havent figured out how turn on the inputs for player 3 and 4.

mccoy178:
Did you configure them in windows with the software provided?  I never could get the software that came with it to work.  I had to open winpad and hit I think "cntrl + p" to access the ipac's menu.  When I used the software (on four computers), it always timed out no matter how I changed the settings.

Lon:

--- Quote from: mccoy178 on March 06, 2006, 03:20:21 pm ---Did you configure them in windows with the software provided?  I never could get the software that came with it to work.  I had to open winpad and hit I think "cntrl + p" to access the ipac's menu.  When I used the software (on four computers), it always timed out no matter how I changed the settings.

--- End quote ---

Yes this is Using the WinIpac IPD software.

Navigation

[0] Message Index

[#] Next page

Go to full version