Main > Software Forum

problem with Fraggal boot cd

(1/2) > >>

POS:
It seems to load fine but will not boot after restart.  It goes to an X: prompt and when I cd to c: and EXE arcadeos it wants to boot from the CD ROM drive.  I know this is an older version and it seems to work with my arcade monitor, does somone recomend a newer better set up

compaq 500 ATI Rage Pro (pc running )

JoyMonkey:
It should only boot to an X: prompt if you still have the CD in the drive. Take the CD out and reboot.

POS:
I have tried but says Abort, Retry, Fail.  It shows a c: but everytime I acess it wants to pull from the CD. 

JoyMonkey:

--- Quote from: POS on February 27, 2006, 02:16:59 pm ---I have tried but says Abort, Retry, Fail.  It shows a c: but everytime I acess it wants to pull from the CD. 

--- End quote ---

During the CDs install procedure, are you sure you created a primary DOS partition and formatted it fully?

POS:
yes it did format.  using the format procedure that comes with the cd.  I used three different drives 1. drive had a linux program on it  i used Fragg's disk deleted non DOS part. formated and installed the programs.  when I rebooted it went to  a Grep prompt.  2. disk didn't work at all wouldn't format  3.disk is the one that i'm currently fighting.   do you have any recomendation on another setup. I just want somthing that will run with my arcade monitor and ArcadeOS runs well with my onboard Video ( ati rage pro)

Navigation

[0] Message Index

[#] Next page

Go to full version