Main > Main Forum

Trimming T-Molding

(1/2) > >>

Lon:
Hi there, i have done a search and not found a method for trimming the overhang of the t-molding flush. I tried using a brand new single edge razorblade, but was not happy with the results, very uneven and the t-molding looked better untrimmed. Is there a method to get a consistant flush cut?

Thanks,
Lon

pmc:
I used scissors once and got a very uneven cut. I got better luck the next time with a sharp utility knife. Take your time and go for a perfect 90-degree cut. Don't rush it. You might want to do some practice runs first.

-pmc

Witchboard:

--- Quote from: Lon on February 26, 2006, 12:57:55 pm ---Hi there, i have done a search and not found a method for trimming the overhang of the t-molding flush. I tried using a brand new single edge razorblade, but was not happy with the results, very uneven and the t-molding looked better untrimmed. Is there a method to get a consistant flush cut?

Thanks,
Lon

--- End quote ---

Are you talking about trimming it in regards to overhang on the sides of the cab, or cutting it when you're finished installing it at the end?

Brax:
How about an edge trimmer for iron-on edging.

http://www.rockler.com/product.cfm?page=1266

Excretious:
That looks handy, thanks for the link  ;D

Navigation

[0] Message Index

[#] Next page

Go to full version