Main > Main Forum

Happ 3" Trackball - no y-axis movement

<< < (2/2)

fiscap:
If I had an extra set of boards or optics, I'd definitely take your approach Peale  :(

Here is what the boards look like. I have no problem with the x-axis optics, which feed into the y-axis optics/encoder board as seen in the picture.

I think the easiest solution is to just buy the new "Red Board" (A052-1011-00) encoder.


SirPeale:

--- Quote from: fiscap on February 04, 2006, 09:03:52 pm ---If I had an extra set of boards or optics, I'd definitely take your approach Peale  :(

--- End quote ---

No, no, no...don't swap them out...swap the ones you already have in the trackball itself.  If when you do that, the problem goes to the X axis instead of the Y, you know your problem is in the board.  If the problem persists, the problem is elsewhere.

Either way, you can rule out problems in this fashion.

Navigation

[0] Message Index

[*] Previous page

Go to full version