Main > Main Forum
Leafswitches - Check this out!!!!!!!!
Farmboy90:
Do we replace just our microswitches with this? Or is this for the leaf switch AND the button? Meaning the button isn't identical to a microswitch button...
Santoro:
Yes, you just replace your microswitch. It will work with existing horizontal pushbuttons.
RandyT:
--- Quote from: JoyMonkey on February 02, 2006, 12:39:03 pm ---I don't think it would work with the RGB-Drive either.
Unless you took a knife to the top of the fixture (where the RGB-Drive gets installed) here...
--- End quote ---
It looks like there is a support structure under there. Removing it might be bad/difficult.
Looks like these were made specifically for the button, rather than a generic micro replacement. Which means, they probably wouldn't work for joys either.
RandyT
mahuti:
Heck, when they come in, I'll buy and test. Since I already have my RGB-drive buttons in, shouldn't be to painful.
Santoro:
Pure speculation here, but with the 'pins' portruding through the leaf gizmo, if those horizontal bits are supports they probably aren't bearing a lot of 'load.' You might be able to get away without one side.
--- Quote from: RandyT on February 02, 2006, 12:47:30 pm ---
--- Quote from: JoyMonkey on February 02, 2006, 12:39:03 pm ---I don't think it would work with the RGB-Drive either.
Unless you took a knife to the top of the fixture (where the RGB-Drive gets installed) here...
--- End quote ---
It looks like there is a support structure under there. Removing it might be bad/difficult.
Looks like these were made specifically for the button, rather than a generic micro replacement. Which means, they probably wouldn't work for joys either.
RandyT
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version