Main > Software Forum

CP SKETCHER

<< < (2/2)

Tahnok:
Correct, there is no zoom feature (this would be quite difficult). But there are ways to make placing parts easier. The already mentioned snap-to-grid is one way. Don't forget, if you make the grid very small you can turn off the grid display while still having the parts snap to it (it can be hard to see through the grid at smaller levels). You can also use the arrow keys to make small adjustments to the last part you clicked on. Or, if you know where you want it to go, you can right-click on the part and set the coordinates manually.

The program does not run correctly at 800*600, you can't see the entire window. Personally, I run it at 1024*768. But if you run everything else at 1080*1024, I don't see why you would be having problems. I guess it is just a matter of personal preference.

ojelela:
Thanks, my problem was I had CP artwork already printed and I had to layout my PB to match it. It had to be dead on. I end up using Adobe Elements 4 and layout my PB and trackball so I can give dimensions to toolmaker in my company to drill lexan for them. By the way, he did real nice job.

All I can do now is wait for Andy from Ultimarc to send me Mag-stiks plus and MiniPac and then down to bussnies.....

Navigation

[0] Message Index

[*] Previous page

Go to full version