Main > Main Forum

Enlarging a hole in a metal CP?

<< < (2/2)

javeryh:
I used the 3/8" metal cutting drill bit and it went through like butter.  I had to file down the edges a bit though because it left them a little raised and I need a flat surface.  I think I can finally finish my last CP this week!

PetitMorte:
For something like this, I would use a T-Reamer. 


This particular tool is designed for making holes larger, and can be used on a wide variety of materials.  It's very precise, and easy to use.  In putting together my cab, I found many uses for it.

Navigation

[0] Message Index

[*] Previous page

Go to full version