Main > Main Forum

Looking for power and video cord connectors

(1/2) > >>

carazy:
I'm looking for a cable or just the ends that will match these spots in the picture.

markrvp:
Post this in the monitor forum and get Ken Layton's opinion.  I'm guessing it requires a .156 connector.  Mouser is a place to get one.




You could probably get one from Bob Roberts as well.

Ken Layton:
Bob Roberts and arcadeshop.com sell these cable assemblies. If you want the bare connector housings and pins then Mouser Electronics has them.

carazy:
I see the video one I want http://arcadeshop.com/pics/vidscab.jpg I was assuming with the power if I can just hook it up to a power cord if I had the right connector.

markrvp:
Ask Ken again about the power connector.  You should post the model of your monitor (and a pic) so Ken can determine if it needs an isolation transformer.  It probably will and you would cause damage if you don't use one.

Navigation

[0] Message Index

[#] Next page

Go to full version