Main > Main Forum
New Product: Opti-Wiz
daywane:
3 axis?
mouse = x and z
x = (east and west)
z= (north and south)
y= up and down?
like a button?
I am confused
I work with mill lathes at work
x - will make the part smaller in diam.
x+ larger in diam
z- shorter in length
z+ longer in length
I have no Y ( I assume "Y" is up and down)
I just do not get it. I must be over thinking this
SirPoonga:
Z is used for the scroll wheel.
RandyT:
--- Quote from: Tiger-Heli on January 03, 2006, 06:36:26 am ---
--- Quote from: PoDunkMoFo on January 01, 2006, 04:31:06 am ---Would you need analog mame to make this work?
--- End quote ---
You will need either XP or Analog Mame to enable two mice controlling separate players, otherwise, no standard MAME will work. (Two-player CABAL, Marble Madness, etc. needs Analog Plus or XP).
--- End quote ---
But not if you are using the axes individually for each controller (say 1 trackball and 1 spinner) or ?
RandyT
markrvp:
--- Quote from: daywane on January 03, 2006, 10:02:15 am ---3 axis?
mouse = x and z
x =
--- End quote ---
Havok:
--- Quote from: RandyT on January 03, 2006, 10:24:45 am ---
--- Quote from: Tiger-Heli on January 03, 2006, 06:36:26 am ---
--- Quote from: PoDunkMoFo on January 01, 2006, 04:31:06 am ---Would you need analog mame to make this work?
--- End quote ---
You will need either XP or Analog Mame to enable two mice controlling separate players, otherwise, no standard MAME will work.
--- End quote ---
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version