Main > Main Forum

WTBorrow 3.25" Hole Saw

<< < (3/3)

LPZ:
I tried a 3", but the hole did not accomodate the black case that the ball is in.  I measured with a micrometer, and it comes out to 3.25 to accomodate it.

quarterback:

--- Quote from: LPZ on December 29, 2005, 05:06:47 pm ---Thanks for all the help fellas. 

Quarterback--Checked the local harbor frieght.  Every size except 3 1/4.
--- End quote ---

Sorry, when I said "something like that", I was actually referring to the post that I quoted with the ASCII drawing of a resizable hole cutter.   My HF had a couple of them.  I'll take a pic of the one I bought.

quarterback:
Here's a pic.  Like I said, my HF had a couple different ones.  In my first post I said I got the one with three cutters, but that's incorrect.  I got the one with two cutting blades because mine will cut holes from 1" to 5" in diameter.  The three-bladed one wouldn't do up to 5" and I needed to cut a 4"+ hole.  The one with three blades was actually 'better' because all three blades would extend from a center disc at the same time.   I couldn't find either one on line, but at my HF they were over near all the drill bits and stuff.

Anyway, here's the pic.

Navigation

[0] Message Index

[*] Previous page

Go to full version