Main > Main Forum

Miter cuts above 45 degrees,??? how

(1/3) > >>

Negativecreep0:
i have a cheapo Ryobi 10" mitre saw now i have to make a 60 degree mitre cut for my control panel. my ryobi goes to 45 degrees both ways not 60 so how do i do 60?? any ideas would be appreciated maybe im just having a brain fart and dont see the obvious....

maxlamer:
If its just for a few cuts use a hand saw, its alot safer than trying to fit a jig into the mitre saw to get the right angle

19rjs99:
Turn the board over and cut it at 30*

Negativecreep0:
the result is still not 60 degrees

Dervacumen:
Maybe if you turn the board over, and move the mitre saw angle to 30* the other direction?

Navigation

[0] Message Index

[#] Next page

Go to full version