Arcade Collecting > Pinball
My Pinball Playfield Swap - Stargate - All Electronics Done!
Buddabing:
The clear may crack with repeated impacts. Thus the mylar. I will also be putting mylar down where the ball drops onto the playfield from the ramps.
ChadTower:
Does mylar offer any protection from impacts? It protects against friction but not sure it gives much against banging.
Buddabing:
I dunno. I was told, "Put mylar around the pop bumpers and where the ball drops onto the playfield". I said, "Yes Sir!" and obeyed.
ChadTower:
Heh. Certainly won't hurt. I've never really thought about it as I have no cleared pins but I figured that the clearcoat would preclude mylar. Maybe I'm mistaken.
Buddabing:
I've reassembled the drop target assemblies after cleaning them. I haven't installed them on the new playfied yet, I haven't changed the decals yet.
Today I rebuilt the flippers. The flipper rebuild kit includes a lot of the parts of the flipper, many of which I don't need. All three flippers show small cracks. I'm thinking about putting some CA glue on the inside of the crack to reinforce them a bit.
It was nice that there were so many parts in the flipper rebuild kit, that way there is a lot less to clean.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version