Arcade Collecting > Pinball
My Pinball Playfield Swap - Stargate - All Electronics Done!
Buddabing:
Well, the old playfield is now out of the cabinet.
Buddabing:
Unfortunately, one end of the playfield dropped before I could secure it. There was some damage. :'( :'( :'(
ChadTower:
That doesn't look too bad. Could have been worse. I've done far worse myself.
I was thinking about this the other day. The new PF you got, it was fully wired, yes? If that's the case, a PF swap is actually not that hard other than mechanically moving the thing into place. I had always thought about moving the wiring and underfield parts as part of the PF swap... if you don't need to do those things, it should be fairly straightforward remove PF1 put in PF2 and connect all the harnesses.
Is this about right?
Buddabing:
No, there is no wiring on the new playfield. It is t-nutted and dimpled, however.
Most NOS playfield are sold with no parts attached.
ChadTower:
So you had to swap all of the wiring over? That is a hell of a job.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version