Main > Main Forum
I-Pac4 driver not loading
mamerJ:
I installed the software to program the I-Pac and now I have to run that app when windows starts or the driver will not load? What did I mess up?
Thanks
Hoopz:
Without knowing specifics on your setup, my first guess would be this take off of Ultimarc's website:
--- Quote ---Problem: (USB Only) Board appears not to work until WinIPAC is run every time. Yellow exclamation marks in Control Panel, Device Manager.
This is a rare problem, and is caused by a registry error. It is suspected that this problem occurs if the board is regularly swapped from one USB port to another, or different board versions used on the same PC. The fix involves registry editing, the usual caution should be observed.
Run regedit, and open Hkey_Local_Machine/System/CurrentControlSet/Enum/HID and delete the keys containing VID D209 Also Hkey_Local_Machine/System/CurrentControlSet/Enum/USB and delete the same keys. You might have to right-click and set permissions to do this. Unplug and re-connect the board.
--- Quote ---
--- End quote ---
--- End quote ---
mamerJ:
:-X oops ... should have look there.
Thanks I'll try that tonight
Hoopz:
I had the same problem after swapping out two different I-Pacs so it was an easy answer. Editing the registry solved the problem right away. Good luck.
jopenner:
I recently had the same problem, but after moving my USB plug to the first USB input on my motherboard, it solved the problem. For some reason it did not like the second port???
Thanks Hoopz for the answer to my question too.
John
Navigation
[0] Message Index
[#] Next page
Go to full version