Main > Main Forum
T-Molding groove too wide!! Help please
MameMaster!:
....I had this problem and tried a totally different approach....COTTON....yep....I just jammed some into the loose spot and then pushed the molding back in....and BAM ...the cotton filled the space perfectly and it didn't pop out anymore.....
If you do it...lay the cotton (thin it out) over the groove and then push the molding in.....that way it wraps around the molding itself and doesn't clog the groove.
Good luck! 8)
Navigation
[0] Message Index
[*] Previous page
Go to full version