Main > Main Forum

Plexi cutting service?

<< < (4/5) > >>

SNAAKE:
Check my thread here http://forum.arcadecontrols.com/index.php?topic=20173.0  8)

Abomination:
mo1e check out the clear polycarbonate, or clear acrylic.  Thats basicly lexan and plexiglas.

mo1e:
and also where do you draw from? is it the two 0 inch points

quarterback:

--- Quote from: mo1e on October 11, 2005, 07:03:28 pm ---hmmm correct me if im wrong but this cant be right i just priced up my so called plexi and it came up to $11.203.75 lol oops its ok i know why now i was buyin 400

--- End quote ---

Does that mean the part you designed was $27 for one?

I'm just curious what the prices run at this place.  I first read about emachineshop.com here on BYOAC a while back and it seems like there's some cool potential there for some projects.

AceTKK:
judging by the pricing guide on their site a single piece is generally fairly expensive.  This makes sense, as most of the cost comes from setting up the machines, checking the toolpaths, etc.  They have some examples where a single piece is $60, 10+ is $10 each, 100+ is $6 each, etc.  Check out their website under the pricing section to get an idea.

-Ace-


-edited for typos

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version