Main > Main Forum

Finishing an edge on plexiglass...

<< < (3/4) > >>

Abomination:

--- Quote from: AmericanDemon on October 05, 2005, 03:47:22 pm ---We built a chopsaw stand once and behind the saw, the guy wanted a plexi shield that curved.
--- End quote ---

Sinner:

--- Quote from: nostrebor on October 05, 2005, 05:58:18 pm ---I would do it just like Bones said, and the flame polish it. The trick to flame polishing is practice,practice,practice... And low heat. I just use a little butane torch from Harbor Freight.

--- End quote ---
What is Harbour Freight??  A store or a brand??

nostrebor:
http://www.harborfreight.com/

daywane:

--- Quote from: Sinner on October 06, 2005, 08:58:22 am ---
--- Quote from: nostrebor on October 05, 2005, 05:58:18 pm ---I would do it just like Bones said, and the flame polish it. The trick to flame polishing is practice,practice,practice... And low heat. I just use a little butane torch from Harbor Freight.

--- End quote ---
What is Harbour Freight??
--- End quote ---

Sinner:
I'm in Canada...with shipping, and with charges for bringing it into the country, I think I could find better deals here...I didn't get a chacne to look around too much (I'm at work), but it looks like they have some pretty kewl stuff...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version