Main > Main Forum

Hooking up a coin mechanism

<< < (4/10) > >>

CheffoJeffo:

--- Quote from: mag48 on September 30, 2005, 06:05:16 pm ---ALL the wires that make the game function are there.... just not the wires to the coin mechanism to the main power supply or whever i connect it

--- End quote ---

On the harness, is there a wire at pin 18?

18 is on the parts side of the board (e.g. not the side that only has solder on it). 8 is where the key (e.g. gap) is. There are 2 sets of 28 pins (1 for each side of the board).

Cheers.

mag48:
umm let me check
i just found thist giant block of wires in the back...

CheffoJeffo:
OK ... now the fun  :-[  part ... you need to trace these wires back to the PCB and make note of which pin they connect to (should be a number between 1 and 28 / parts side or solder side).

From that, we should be able to tell which wire to connect where ... and that's 95% or the battle.

Cheers.

CheffoJeffo:
Bump to see how it went with the folks in the chat room last night ...

mag48:
ok... lol i really need a picture by picture step by step thing to show me how to do this lol

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version