Main > Main Forum
How do I mount this coin door?
KungFuJoe:
I bought this off ebay but I guess I should have checked to see if it came with a mounting frame...which it didn't.
spystyle:
I mounted a coin door without a frame and it works just fine.
Dig it?
Craig
whammoed:
Before you mount it you may want to buy her dinner first, maybe even a movie. ;)
Seriously though, If you are good with a router looks like you could cut an appropriate size hole for that door and use some long screws (pilot hole first) to mount it.
KungFuJoe:
Hmm...and you don't worry about it ripping out of the MDF with the screws being so close to the edge?
spystyle:
I wouldn't worry about it at all, 3/4" MDF is tough stuff.
Use washers on the back.
Maybe if you remove the coin door guts you can place it flush against the material and trace it. Then match it with hole saws and jigsaw, or router with straight cutting bit.
Good?
Craig
Navigation
[0] Message Index
[#] Next page
Go to full version