Main > Main Forum

slot cutter bit for t-molding

(1/1)

Nataq:
Wich ones of these would be the good one for cutting the t-molding groove ?


http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html

the 3-wing 1/16 is what I need ?

RetroACTIVE:
Depends upon how wide your t-molding is...

1/16" is the correct cutter for 3/4" or smaller t-molding and 5/64" is the correct cutter for 13/16" or wider t-molding...

following www.tmolding.com recommendations.

Nataq:
I need 1/16. Im just wondering if this 1/16 bit on this page is really what I need :)

RetroACTIVE:
yup... just be sure to buy the whole thing if you don't already have a shank and bearing.

Nataq:
thanks :)

Navigation

[0] Message Index

Go to full version