Main > Main Forum

27" monitor bezel from Happs

(1/2) > >>

KungFuJoe:
I was on their site and I saw this product.  Is it any good...seems like a good enough price. 

Also, does anyone know the full dimensions of the 27" bezel?  I tried emailing them but got no response.  Is the bezel easily trimmed to fit your cab (in case it's too wide).

...just basically looking for opinions...

Taborious:
Actually the bezel is small/narrow, my cab is 29" wide on the interior and the bezel was too narrow and didn't make it from side to side. I had to go to a frame store and buy the cardboard framing you see in pictures and cut out the center and glued the bezel to the back. looks OK but I was surprised that the bezel wasn't wider to allow you to trim it down...

KungFuJoe:
Was afraid of that.  I wonder where I can get a bezel that is wide enough...I've got probably 32-34" width in my cab.

paigeoliver:

--- Quote from: KungFuJoe on September 21, 2005, 07:15:03 pm ---Was afraid of that.  I wonder where I can get a bezel that is wide enough...I've got probably 32-34" width in my cab.

--- End quote ---

Unfortunatley the answer to that question is no where.

armax:
http://forum.arcadecontrols.com/index.php?board=1;action=display;threadid=3367;start=msg19994

here ya go.

Navigation

[0] Message Index

[#] Next page

Go to full version