Main > Main Forum
My design + some important questions
The cranky hermit:
I designed this using MameRoom Designs CP Designer. A couple of notes about it:
I'm going to put a Ms. Pacman/Galaga 4-way joystick in that space above the trackball between the four buttons, using an Oscar mounting plate.
I'm going to use a Slikstik Tornado spinner, not an M3.
Also, I have some specific questions:
Is the Oscar mounting plate for the M3 spinner the same as the Oscar mounting plate for the Ms Pacman/Galaga 4-way joystick? That is, if I were to add an "Oscar Controls M3 w/plate" to the design, would the space they routed out there accomodate my 4-way joystick mounting plate? (I realize that if it did, I would still have to cut out a bigger hole to accomodate the joystick itself. I can do this.)
Would the hole they cut to accomodate an M3 spinner in the upper-right corner, also accomodate the Tornado?
Finally, is there anything wrong in general with the control panel?
Thanks in advance
The cranky hermit:
More images:
GGKoul:
Looks pretty standard.
The cranky hermit:
Left and front:
The cranky hermit:
Rear and bottom:
Navigation
[0] Message Index
[#] Next page
Go to full version