Main > Main Forum

How do I assemble this slot cutter?

<< < (2/3) > >>

Zakk:
I've got one that came pre-assembled.  The washers are on both sides of the bearing (like the Zod thread).  Closer to the nut there is two washers on mine, so it would be 1,2,3,4,7,7,6. 

Wow, I never imagined that a Zod post would actually add anything meaningful to the forums!  :D

AceTKK:
Cool, thanks for the info!

nostrebor:
I posted a pic of the assembly in this post.

http://forum.arcadecontrols.com/index.php?topic=25426.0

Make sure that the blade is not put on upside down. If it is, the cutter will smoke like crazy when cutting, and it will ruin the cutter if used this way for long.

AceTKK:
Quote from the other thread

"... its bearing,washer,cutter,washer,nut. This might help others get a picture in their mind"

So opinions are still varying on the proper placement for the washers.  It's pretty clear that the bit works either way, so I'm not going to stress out about it.

-Ace-

DaveMMR:

--- Quote from: nostrebor on September 17, 2005, 04:37:23 pm ---Make sure that the blade is not put on upside down. If it is, the cutter will smoke like crazy when cutting, and it will ruin the cutter if used this way for long.

--- End quote ---

Ohhhhhh.... that's why......  Turns out I had it on backwards.  Good thing I was doing quick "test" cuts on spare wood before going "live" with it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version