Main > Main Forum
OK to route tmolding slot while cab is upright?
jedi27:
Practice routing on some scrap wood... try routing vertically - you might do alright...
HOWEVER - I would strongly recommend you lay the cab on it's side - go for the horizontal..
Routing is also VERY dusty - especially on MDF. Empty your cab - you don't want the dust getting everywhere - especially your trackball bearings...
Get that paint straightened out - if it's tacky now, imagine how your finish will appear with all of that sawdust on it..
Stingray:
--- Quote from: jedi27 on September 16, 2005, 12:11:11 am ---
Get that paint straightened out - if it's tacky now, imagine how your finish will appear with all of that sawdust on it..
--- End quote ---
Also a valid point.
-S
Navigation
[0] Message Index
[*] Previous page
Go to full version