Main > Main Forum
Leaf button/switch experts: Help!
whammoed:
I woul like to use leaf buttons on a cocktail panel but space is *very* tight.
Knievel:
If those red dots are meant to show the spot where the button will be pushing you'll be fine.
It'll just take slightly more pressure to make contact with yours.
whammoed:
--- Quote from: Knievel on September 12, 2005, 12:05:16 pm ---If those red dots are meant to show the spot where the button will be pushing you'll be fine.
It'll just take slightly more pressure to make contact with yours.
--- End quote ---
Yes.
thanks for the confirmation. I think you're right. I notice that the new style holders (like bob roberts sells) put the actuation point further out than the older style I have. The ones I have put the actuation point directly at the contact points where the bob roberts style put the actuation point closer to the end of the leaf. I suppose there's no reason moving the actuation point in closer wouldn't work as well.
Knievel:
Ah yes mine are like his then, that's why I wasn't sure about the dots.
On these ones the contacts are 1 3/8" long from the mounting block to the tip if that helps you any.
They look a lot longer in your pic.
whammoed:
--- Quote from: Knievel on September 12, 2005, 12:35:47 pm ---Ah yes mine are like his then, that's why I wasn't sure about the dots.
On these ones the contacts are 1 3/8" long from the mounting block to the tip if that helps you any.
They look a lot longer in your pic.
--- End quote ---
thanks, I see now that the difference between mine and yours is the length of the leafs, not the holders. Same idea though.
Navigation
[0] Message Index
[#] Next page
Go to full version