Main > Main Forum

T-molding and rubber mallet

(1/3) > >>

bravesfan:
I used a rubber mallet to install my t-molding.  However, the rubber mallet seemed to put some small dents in the molding.  Is there any way around this?

versapak:
Don't pound so hard?


After all... The whole point of using a rubber mallet to install the t-molding, is so that doesn't happen.


Minwah:
I found it quite hard to install evenly tho to be honest.  It's easy to push the molding in *too* far.

ahofle:
Use a soft towel folded a few times where you hit.  This worked really well for me and avoided the scuffs and imprints.

Stingray:
I always just push t-molding in by hand. I've never seen the need to use any tools for that particular job.


-S

Navigation

[0] Message Index

[#] Next page

Go to full version