Main > Main Forum

Any way to add graphics to SlikStik?

(1/2) > >>

Skadar:
I recently ordered a SlikStik classic.  As I'm sure you know, these units are finished with a black laminate.  I was wondering if anybody had figured out a way to add custom graphics to the top of a SlikStik unit.

I haven't really turned up anything through searches.

Thanks!

pointdablame:
Art + plexi would probably be the easiest way, but unfortunately your T-molding will no longer cover the entire side... the height of the plexi will be above the T-molding's edge.

Or just have the art printed on adhesive backed vinyl.  Remove the controls, stick the art down, cut holes, replace parts..... done.  You shouldn't have a problem with T-molding so much with this option since the vinyl will be relatively thin.

Stingray:
Vinyl would be the best option IMO.

-S

Timoe:
Try www.mamemarquees.com for Control Panel Overlays.  You might have a bump where your trackball mounting plate is or you could run the art under the mounting plate and have a big black square.

Skadar:
Thanks for all of the suggestions!

Navigation

[0] Message Index

[#] Next page

Go to full version