Main > Main Forum
Cutting T-Molding to Length
javeryh:
Thanks for all the suggestions - anyone else have a method that requires less eyeballing and is more idiot-proof?
nipsmg:
Do you have a t-square? or anything that' make a 90 deg angle?
If so, lay it flat on its back, trim off the barbed edge with a razor knife. align an inside edge of the T-Square with the edge of the molding, move the t-square so the perpendicular piece is exactly where you want it, and run the razor knife along the perpendicular edge of the t-square.
No eyeballing, perfectly straight cut.
AceTKK:
use scissors?
whammoed:
I use a pvc pipe cutter. Not something I bought for t-molding, already had it. Works great.
Navigation
[0] Message Index
[*] Previous page
Go to full version