Main > Main Forum
molding - not "t" style
muttonchop:
--- Quote from: quarterback on August 25, 2005, 12:14:14 am ---The stuff in my Lowes is in an aisle that's just before you get to the raw wood aisles
--- End quote ---
Found it! Its funny, no one knew where it was, so i went to the dowels area, they were messing with the layout of the store, and it was all in a big card board box where the dowels used to be O_O
this stuff doesnt look anywhere as good as t-mold, and its kinda a pain to get on, but it does the job, and it doesnt look half bad. I also bought a roll of the facing, and that stuff is REALLY nice, if it wasnt so pricey, id do the whole cab in it.
quarterback:
--- Quote from: muttonchop on August 29, 2005, 08:38:36 pm ---
--- Quote from: quarterback on August 25, 2005, 12:14:14 am ---The stuff in my Lowes is in an aisle that's just before you get to the raw wood aisles. It's in the same aisle as some wooden dowels
--- End quote ---
Found it!
--- End quote ---
Raven..:
I have used the white birch iron-on trim for my Ms Pac/Galaga/Frogger in a former Galaxian cab. I stripped the cab down to the beutiful butter-colored plywood and couldn't stand to put plastic T-molding on it. This stuff looks really nice!
I also used the white melamine trim on my Popeye to SMB conversion. It looks good, but trimming the width is a pain.
darthbane2k:
--- Quote from: EyeDoc on August 30, 2005, 02:07:28 am ---I have used the white birch iron-on trim for my Ms Pac/Galaga/Frogger in a former Galaxian cab.
--- End quote ---
Raven..:
--- Quote from: darthbane2k on August 30, 2005, 07:07:33 am ---
--- Quote from: EyeDoc on August 30, 2005, 02:07:28 am ---I have used the white birch iron-on trim for my Ms Pac/Galaga/Frogger in a former Galaxian cab.
--- End quote ---
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version