Main > Main Forum
Wire Help
topdawgg:
Thanks for all the help. One last quick question (and no I didnt search for an answer) do the grounds from the buttons/joystick/trackball get connected together and then one wire from them being connected together goes to the ipac or keywiz that I am using?
Thanks.
pointdablame:
yes
topdawgg:
So I dont need a wiring block? Seems like alot of wires to be connected together ... 20 buttons... 3 joysticks = 32 wires? So just tie all 32 wires together with some type of big crimper and then one wire comes out to the encoder?
LPZ:
Daisy chaining them together would be alot eaiser. What I mean by "daisy chaining" is leap from one button ground to another and so on, etc. Run a lead ground wire to button #1, daisy chain the rest , and on the last button, run another lead ground wire back as a return. This way if the chain breaks somewere, you won't lose the rest of your inputs after the break in the chain. :)
topdawgg:
"run another lead ground wire back as a return"
On the last button you state to run another lead ground wire back as a return... where does this wire go? Back to the encoder or back to button 1? I believe by lead ground wire you mean back to the encoder... so there would be 2 wires hitting the encoder... one form button 1 and one from button last and everything else in between is daisy chained?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version