Main > Main Forum
Does anyone manufacture "brown" pushbuttons?
danny_galaga:
yeah, casting is the go i reckon. theres a few members here who cast parts for models, etc. and the results are great. buttons would be a cinch...
rdagger:
You could get clear buttons and paint the inside brown.
HaRuMaN:
--- Quote from: rdagger on August 15, 2005, 02:34:38 am ---You could get clear buttons and paint the inside brown. This would give a clean finish and prevent the paint from rubbing off. You could also illuminate clear buttons to brown. I think a red and a green LED would give you brown. The buttons on my cab rotate colors including brown, but I'm using RGB LED's with a custom board.
--- End quote ---
That's a good idea! :o
Navigation
[0] Message Index
[*] Previous page
Go to full version