Main > Main Forum

Speakers

<< < (3/4) > >>

USSEnterprise:
I remember when my parents used this system before we got the surround system, there were always two, Large, 3 way floor speakers hooked up. I went down in the basement to check them and they were 200 watt, 8 ohm

Level42:
Sorry about crashing in like this....but I am actualy planning on the following:
Got 2 B&W DM110i speakers, but one has a blown-up bass unit. Is there a way to connect one bass unit and mix the left and right signals for the bass frequencies only ?
Then I can use the tweeters to keep the stereo effect...

Want to connect them to an old JVC amp, plenty of room for it in my cabinet ;)

Thx

USSEnterprise:
Why not just get a foam ring kit for the other speaker? they are pretty cheap

whammoed:

--- Quote from: SirPoonga on July 27, 2005, 01:19:12 pm ---I would htink 4ohm load would work, but would get like 60watts.
--- End quote ---

USSEnterprise:
so, would hooking up a 4 ohm woofer, a 8 ohm mid range, and a 4 ohm tweeter do damage

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version