Main > Main Forum

Cutting a t-molding groove without a t-slot cutter.

<< < (2/3) > >>

giza:
Maybe using a chisel and mallet would get the slot that you need.

Bones:
Solution found.

A biscuit cutter.

CJK:
Good solution -- I was going to recommend a Japanese throwing star, but the biscuit cutter will probably work out better.   8)

-- Chris

daywane:
those things are not cheep!!!
Maybe now they are ( have not looked at them in a few years.)

steptoe:
if ya can get a biscuit cutter in there, why wont the router fit, ive been thinking about using a piece of stainless sheet ground to look like a router bit, should be strong enough and rip the mdf easy, make it any size you like

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version