Main > Main Forum

Happs trackball (parts needed)

<< < (3/4) > >>

SirPoonga:
Wwonder, www.therealbobroberts.com

Also, it makes sense that the new part is better, that's a good reason it got replaced.   They made a better version :)  Or is it the fact that the first part the company decided to no longer make it and the other part is a different company's equivilant.

WwonderLlama:

--- Quote from: SirPoonga on July 27, 2005, 11:35:05 am ---Wwonder, www.therealbobroberts.com

Also, it makes sense that the new part is better, that's a good reason it got replaced.   They made a better version :)  Or is it the fact that the first part the company decided to no longer make it and the other part is a different company's equivilant.

--- End quote ---

Thanks for the pointer to Bob Roberts. (I'd tried going there yesterday, but couldn't get to the site... Just tried.. still can't get anywhere. I get a 404 error.)  I expected the new part would be about the same, but their technician couldn't tell me whether it's electrically compatible, so I figured I should dig in the docs.

Thanks for the input :)

u_rebelscum:

--- Quote from: quarterback on July 25, 2005, 12:42:40 am ---Will a Betson PCB fit into a Happ TB?  The boards done look exactly the same, but I'mnot sure what the differences are on the interior of the TB case.

--- End quote ---

Okay, checked.  The Wico and Betson/Imperial I have are almost swappable: the betson fits in the wico, but the wico is just this[/t] much too wide to fit in the betson.  I bet I could sand the PCB a little and it would fit, though.

However, the betson/imperial/wico PCBs are shorter than the Happs, and so don't lock into the happs TB cases.  And the happs are too long to fit inside the betson/wico cases.  You might be able to extend the betson PCBs to be held correctly in the happs, but not that easy is my guess.

gonzobrian:
WwonderLlama, Bobs site seems to be down I get the same error and I just ordered from him a few weeks ago.

Toonces:

--- Quote from: WwonderLlama on July 25, 2005, 11:28:50 pm ---Thanks for all the replies.

Okay, so if I decide to buy a new red encoder, it sounds like I should go to Bob Roberts... Can you point me in his direction?  How much was the shipping fee?

Thanks much,

Phill W.

--- End quote ---

Bob's site is up at http://www.homearcade.org/BBBB/parts.html

It looks like his DNS redirect isn't working so you get a 404 at the other URL. I know he's alive and shipping as I just got notice on parts I ordered today.

Toonces

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version