Main > Main Forum
New Product: Versa49 (TM) Balltop Replacement Shafts for HAPP 49-Ways
Minwah:
--- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion.
--- End quote ---
I can take a pic when I get home...
If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm). If that helps at all...
SirPoonga:
--- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led? I'm guessing no but thought I would ask to be sure.
--- End quote ---
Looking closely at the pics, the shafts are not hollow.
Popcorrin:
--- Quote from: SirPoonga on July 26, 2005, 10:02:49 am ---
--- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led?
--- End quote ---
--- End quote ---
SirPoonga:
Well, look at the side by side pic with the bat-top. The shaft comes to a point, therefore I doubt it is hollow.
Toonces:
--- Quote from: Minwah on July 26, 2005, 04:46:43 am ---
--- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion.
--- End quote ---
I can take a pic when I get home...
If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm). If that helps at all...
--- End quote ---
Thanks Minwah! That helps a lot. I think they'll work for me.
Toonces
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version