Main > Main Forum
ikari warriors - better memory
19rjs99:
Try switching the ends of the cables from the board to the stick. I know they only connect correctly in 1 direction.
MameMaster!:
DaWaynes suggestion is a good one.
When I was experimenting with a similar ribbon cable I just used a small point (from a mini screwdriver set) to push against the silver connector in the plastic part (I forget what it's called).
That pushed down the tiny metal piece that held it in place w/o breaking it.
You can then reinsert/switch wires at will. Look closely at this pic-- on the left where the ribbon cable attaches to the rotary connection is the "plastic part" I'm talking about. On the top...you can see the silver of the connectors. Just insert someting pointy in there....and the cable should release.
Just do it carefully and you'll be fine.
sp0rk:
Thanks. never would have occured to me to just take the pins out of the connector. That's why I love getting objective opinions. I'll probably do it tonight and let you guys know how it goes! I'm guessing I'll just have to reverse all the pins? Thanks again.
MameMaster!:
hmmm......if you reversed all of them can't you just reverse the connector?....(now that I think about it!) ie- unplug....turn over...and plug back in.
19rjs99:
You need to unplug the cable from the board and plug it into joy and the end from the joy into the board. This should reverse the wiring.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version