Main > Main Forum
Has anyone ever made a swapable CP for old Atari cabs?
HoopstarsGarage:
--- Quote from: ChadTower on July 14, 2005, 02:49:14 pm ---Ah, so it's not an exact thing, it's eyeballed and ground out. Gotcha.
--- End quote ---
Kinda.. I found out the radius measurements for the top and bottom curves, marked them out on two small pieces of cardboard and then cut them out to use as templates. As I was nearing the "eyeballed" radius on the control panel, I would use the cardboard templates to continually check the radius.
Finally, I used high gloss paint on the surface and my "above bench mounted" 3" fluro to check the continuity across the length of the panel for "linearity"..
I came out quite nicely indeed.. which it kinda needed to - otherwise the overlay would have puckered up and not sat nice and flat..
Navigation
[0] Message Index
[*] Previous page
Go to full version