Main > Main Forum

Cabinet design- opinions wanted

<< < (2/2)

Truecade:
Thanks for the input everyone.   Here's some answers to a few questions-

The big square in the middle of the CP would be for a 3" trackball.  I used the dimensions from the HAPP site since I've only install the 2.25" version from Ultimarc. 

I originally had a little bump out at the bottom to increase the depth by another 4", but the bottom removable panel would have been harder to mount than if it was straight.  I also considred just making the whole back straight, but I like the look better this way.   I think the center of gravity for the TV should be in the middle of the cabinet, so hopefully there won't be any stability/safety concerns.  :o

This cabinet would be to sell.  My brother-in-law's friend saw my UA-I and wants me to build him one.  However, I wasn't very happy with the UA-I design and wanted to try my own hand at designing a cabinet that I could cut and assemble easier.  We'll see how it goes....  8)

Bones:
I personally would suggest a bit more of a buffer for the rear of the monitor.

It looks like a tight squeeze and if for any reason you have to set the TV back further than you anticipated, I think you will run out of room real quick.

Navigation

[0] Message Index

[*] Previous page

Go to full version