Main > Main Forum
p360 ball top
spiffyshoes:
Happ allready makes the spacers. They come with the P360. You can order just the spacers from Happ though. You might try ordering them through PonyBoy.
quarterback:
--- Quote from: spiffyshoes on July 04, 2005, 02:57:51 am ---Happ allready makes the spacers. They come with the P360. You can order just the spacers from Happ though. You might try ordering them through PonyBoy.
--- End quote ---
Are you referring to part 95-2470-00? (that's the 5/32" metal sleeve used when you're mounting P360s on a metal panel) I don't know if it's the right size to make the SlikStick shaft fit into a Wico base, but interestingly enough, it's the exact thickness that I determined was right to make a Wico shaft fit into a Ms. Pac Reunion base.
So, if you buy the SlikStik P360 shaft, does it require you to use the metal sleeves that come with the Happ P360?
Hmmm....
rdagger:
--- Quote from: markrvp on July 04, 2005, 01:49:43 am ---If I have read correctly, the P360 sticks are slightly longer than the Wico sticks. In this case, a Wico stick works in the P360 by basically compressing the hell out of the spring so that you can get the E-clip into it.
--- End quote ---
The Wico stick is about 1/16" too short for the P360. So you don't have to compress the spring too much. Here's my page on the conversion.
The spacer bushing that came with my P360's needed to be cut to 1/2" for a wood CP or 5/32" for a metal CP. Since this stock bushing is longer than you need, you could just cut the appropriate size spacer from the bushing. When installing the Wico in the P360 you don't use the bushing because the top part of the Wico shaft is already longer than the P360 shaft.
xonix_digital:
--- Quote from: rdagger on July 04, 2005, 01:09:18 pm ---The Wico stick is about 1/16" too short for the P360. So you don't have to compress the spring too much. Here's my page on the conversion.
--- End quote ---
Isn't that font under your Joystick from like star trek or star wars or something?
sorry, OT. :D
-=XD=-
Kremmit:
If the only problem with the SlikStik p360 replacement shafts is that they're too long below the stepdown, then the spacer ought to cure the problem. Or dremel a new e-clip groove higher up. Or put a hardware store 19 cent nylon spacer between the e-clip and the actuator. Or a stack of washers, for crying out loud.
There must be somebody with a Slikstik p360 handle and a Wico joy that can test this.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version