Main > Main Forum
IPac Losing Programming
vibez:
--- Quote from: dot on December 12, 2005, 08:31:16 am ---Did you guys ever get this figured out? Mine has recently started doing the same thing. I'll have to try the registry stuff when I get home tonight.
Thanks.
--- End quote ---
The 1st time I got it sorted using a new epprom. the 2nd time I thought it was happening again. Basically the drivers had got corrupted. I just unistalled the device & plugged it back in. Windows installed the drivers again & all is good now
Bill Mote:
I read on the Ultimarc site that the problem can be caused by frequently swithing the USB port the device is connected to. That's a possibility as I recently reworked the control panel to replace all the crimped connections with soldered connections. I also moved :) That means it's possible that the CP was moved to at least 2 new USB ports.
dot
walls83:
--- Quote from: AllisterFiend on July 04, 2005, 06:09:43 pm ---
--- Quote from: LandShark on June 24, 2005, 11:32:39 am ---Ok - after a few emails with Andy, I believe this problem I was having has been fixed. I completely overlooked looking at the control panel in windows (device manager) or that would have tipped me off right away. I think sometimes you forget that your control panel is being recognized by the computer as a keyboard and will show up there.
--- End quote ---
--- End quote ---
Doc-:
Mine does not work either (USB) - I have to reprogram it every time. I contacted Andy some time ago and he said to ship it back to England due to a bad EEPROM. I figured by the payed for overseas shipping again and then went through all the hours of rewiring it I would have spent more time/money than it was worth.
I now have the IPAC panel on autoboot, so I just press the program button once it comes up and then start up MAMEWAH.
Doc-
brophog:
Doc,
Have you tried to load an ipc file through mamewah instead?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version