Main > Main Forum

Is this a good price for smoked lexan?

<< < (2/3) > >>

nyconx:
I think my problem is that I called a glass shop.  I need to find a plastics company. 

What do you guys look under in the phone book to find a plastics company that would do such a thing? any helpful tips?

Thanks

Granger:
As far as cutting the plexi/lexon yourself, a cutter goes for about $5. just score the plastic (using a straight edgeas a guide) and snap it off.

Stingray:

--- Quote from: nyconx on June 16, 2005, 07:26:11 pm ---I think my problem is that I called a glass shop.  I need to find a plastics company. 

What do you guys look under in the phone book to find a plastics company that would do such a thing? any helpful tips?

Thanks

--- End quote ---

I know this sounds tricky, but I looked under "plastics". ;)

-S

TOK:
I wanted to use the original bezel that came with my cab, but wanted the darker look, so I tinted with automotive tint. It made a HUGE difference in the appearance of the machine and was very inexpensive to do. I'm sure this could be done with clear plexi, too. I used 20% tint for mine, but even 15% (lower number is darker) would be good.

FractalWalk:

--- Quote from: AlanS17 on June 16, 2005, 05:01:38 pm ---The smoked glass hides the fact that you don't have a bezel underneath (assuming you have no bezel) so you don't see everything around the inside of the machine.
--- End quote ---

The other benefit is that it makes the picture look better.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version