Main > Main Forum
can i use dremmel for tmolding?
alundra:
can someone post a picture of a router drill bit for tmolding? and can the router carve custom holes, like a half depth square hole for mounting joysticks...sorry i never work on these stuff before..thanks
bjk7382:
--- Quote from: CJK on June 14, 2005, 11:01:36 pm ---You have clearly never used a plasma cutter.
--- End quote ---
IntruderAlert:
--- Quote from: CJK on June 14, 2005, 11:01:36 pm ---
--- Quote from: xonix_digital on June 14, 2005, 09:57:06 pm ---ROTO-ZIP!!!
Thats all I gotta say. It's like a diesel Dremel/Router thing. With the right attachments it is the sickest cutting tool I have used. Good Luck!
- XD
--- End quote ---
You have clearly never used a plasma cutter. 8)
http://www.torchmate.com/torch1.jpg
-- Chris
--- End quote ---
oooh.. i want one of those 8)
Chris:
I've used a Dremel for cutting T-molding slots in a CP. For a CP, a Dremel is fine. I would NEVER try to use it for a whole cab!
Also, after cutting slots for 2 panels and using it with the routing attachment to route a space for a joystick plate, the Dremel burned out.
--Chris
alundra:
ok, i just bought a router..but i dont know which bit is for tmolding..i ask a couple guys at Home Depot and none of them know.. i saw there is a blade call "3 wing slot cutter" but it just a blade, it doesnt have any handle to attach to the router...dont know if the right one..can someone here give me an example for 3/4 molding slot? thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version