Main > Main Forum
GunCon2 on PC-monitor
rbarr110:
Anyone have any new updates on this using the updated/modified J-pac chip?
fl0yd:
I haven't had a chance to build the circuit yet, but I hope to do so in the next week or so.
Any others?
olsteve:
I built the circuit with the 'new' chip. I can't get it to work. I have tried both drivers (smog's, wingun). I took it back apart and verified that I have the wiring correct. I am using XP. I can not get the gun or screen to recognize each other at all. Any ideas?
rbarr110:
--- Quote from: olsteve on November 08, 2005, 06:57:45 pm ---I built the circuit with the 'new' chip. I can't get it to work. I have tried both drivers (smog's, wingun). I took it back apart and verified that I have the wiring correct. I am using XP. I can not get the gun or screen to recognize each other at all. Any ideas?
--- End quote ---
How is the circuit wired to the monitor? Any pics to how it is connected?
Video card ----->circuit-------->monitor
|
--------->Light gun
?
olsteve:
I have it wired using a vga splitter cable. The monitor looks fine. When I go into the calibration screen there is no response at all to gun movement. The trigger does activate the screen flash. I can get the cursor to move with the trackball but nothing with the gun.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version