Main > Main Forum

Carbon fiber cutting

<< < (2/2)

AlanS17:
Unless it's prone to cracking, I'd say get that saw moving as fast as you can and just cut through it as quickly as possible. A slow saw is what will cause splintering.

rdagger:

--- Quote from: AlanS17 on May 31, 2005, 06:28:56 pm ---Unless it's prone to cracking, I'd say get that saw moving as fast as you can and just cut through it as quickly as possible. A slow saw is what will cause splintering.

--- End quote ---
It's recommended not to use a fast saw because it means more dust.


--- Quote ---Isn't WD-40 flammable?
--- End quote ---

danny_galaga:
cut same way you would fibreglass. wear a dust mask. i dont think you need coolant for it but if you do dont get electrocuted!

Navigation

[0] Message Index

[*] Previous page

Go to full version