Main > Main Forum

Newbie CP design...

<< < (7/8) > >>

markrvp:
What layout did you decide to use, the angled or straight? 

If you chose straight across then cutting the pieces to angle is a snap.  If you are using the original angled layout, then it is going to be more difficult.  I'm not sure I would have tried it on my 4P panel if I hadn't had a compound mitre saw.

Veinman:
I sloped mine towards the front, and to do it I used a bandsaw on all the pieces. Then, once you have the panel sides all together, you sand until everything is on a nice and even slope.

Watch those fingers! ;)

Sinner:

--- Quote from: markrvp on June 03, 2005, 01:56:22 pm ---What layout did you decide to use, the angled or straight?
--- End quote ---

Sinner:

--- Quote from: Veinman on June 03, 2005, 01:57:09 pm ---I sloped mine towards the front, and to do it I used a bandsaw on all the pieces. Then, once you have the panel sides all together, you sand until everything is on a nice and even slope.

Watch those fingers! ;)

--- End quote ---
Thanks...i don't own one, but I suppose I could rent one...is it better to slop the CP??

CheffoJeffo:

--- Quote from: Sinner on June 03, 2005, 01:45:13 pm ---Is it better to have the CP slope towards the front, or is it OK to have it as a flat box?
I have limited skill, and I've never done this kind of stuff before.  I only have a few tools, and I'm not sure if I could actually build this on an angle without buying more.
I currently own...
Jigsaw
Circular saw
Router (plunge and fixed base)

I was thinking of buying a mitre box and a hand saw for cutting the angled pieces on the CP box, but I'm not sure how to slope the box.  Good idea to use a mitre box?

Making the whole thing slope towards the front poses another problem...


--- End quote ---

You could always build a flat box and just angle the mounting in the cabinet.

The CP enclosure on my multi-jamma would be 100% flat if you pulled it out of the machine, but it is tilted forward in the cabinet.

Does that make sense (didn't sleep much last night) ?

Cheers.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version