Main > Main Forum
Anyone got a Super or Sanwa stick? Need dimentions please.
Franco:
Im making some more stainless dust washers for a couple of people tomorrow. Has anyone got a Happs Super and/or a Sanwa stick that you could measure and post the shaft diameters? The diameter I am after is the one shown on the pic at the bottom of the post.
If anyone else wants any washers let me know before tomorrow and I will be able to get them sent off tomorrow afternoon. I can also make some next week but it just means you will recive them later. They are $10 per pair. Shipping to the USA from the UK is $4 for one pair or $5 for two.
If you have a stick apart from a Wico can you please send me the shaft diameter or the diameter of the hole in your current washer.
Thanks.
whammoed:
I can get measurement tonight (super) if no-one responds sooner. Do you want the diameter of the metal shaft or the plastic sleeve? On a super the dust washer goes around the plastic sleeve.
Franco:
Thanks mate.
Thats a good point. If you can give me the diameter of the plastic sleeve or the diameter of the hole in the plastic washer that would be great.
NIVO:
I can tell you the diameter of the shaft of a super is 10mm. :)
ShinAce:
The dust washer measures:
2 1/8" total (or 54 mm)
5/8" inside diameter (or 16mm)
My measurements were in inches, then converted to mm.
Also, the circumference of the washer is tapered.
Navigation
[0] Message Index
[#] Next page
Go to full version