Main > Main Forum

Stainless steel dust covers *Other custom work too*

<< < (2/8) > >>

markrvp:
I would definitely be in for a pair.

crashwg:
Ooh ooh ooh, me too!  ;D

Franco:
Ill look forward to seeing the marquee knievel.

If anyone would like a pair, post or PM me the following info and I will see what I can do.

DIMENSIONS:



D1 - Outside Diameter
D2 - Bore Diameter
D3 - Width

EDGE PROFILE:



A - Flat with chamferd corners to remove sharp edge
B - Full radius and chamfer.
C-

Kremmit:
Franco-

Figured if we're taking measurements, we oughtta post 'em, so you don't get 50 people all measuring the same joystick.

Here are the measurements for a Wico leafswitch joystick dustwasher.  These are almost certainly good for a Happ Perfect 360 joystick as well, but since I don't have one of those, I wont' say that's for sure.

d1 - outside diameter:  2 inches / 51 mm

d2 - bore diameter:  7/16 inch / 11 mm  update:  This measurement was VERY snug.  I'd go with at least 15/32 or 11.5 mm next time.

d3 - thickness:  1/16 inch / 1.5 mm

Original Wico dustwashers have a dead flat edge profile, but I like B:  Full Radius and chamfer.

You've got PM!

Franco:
I have just finished making four of the above washers to Kremmits Wico dimensions. Ill post some pics of them tonight.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version