Main > Main Forum
OT, sorta - laminate
cbmeeks:
I have a large piece of plywood (rough grade). It is 6.5' long and about 32" deep.
I want to make a computer desktop out of it.
What do you recommend covering it with? laminate?
Thanks!
cbmeeks
Tailgunner:
How rough is it? Do you know what grade it is?
Avery:
I have seen large sheets of counter top type material out there that might work. You can also buy veneer, real hardwood cut a 1/16 or 32nd of an inch or so think, but depending on what you mean by roungh, you might be better off if you glued a quarter inch thick piece of high end plywood to what you've got. It'll be a bit pricey (at some point you stop paying for wood and start paying for smooth) but I think you are in for a mess of work.
cbmeeks:
thanks guys.
by rough, I mean the stuff that is used for walls. Real rough. As in don't run your hand down it.
I would really like to use it somehow because it was free.
SteveJ34:
--- Quote from: cbmeeks on May 12, 2005, 11:59:30 pm ---thanks guys.
by rough, I mean the stuff that is used for walls. Real rough. As in don't run your hand down it.
I would really like to use it somehow because it was free.
--- End quote ---
Ah, childhood memories....
A piece of lumber like that in combination with some scrap 2x4 bracing would probably have been fashioned into a ramp to jump our bikes off of.....
Navigation
[0] Message Index
[#] Next page
Go to full version