Main > Main Forum
Fiberoptics as t-molding??
Veinman:
WOW that is one hideous "website."
IMO, that much light might get distracting, but it sure would look cool.
cholin:
--- Quote from: Veinman on May 09, 2005, 10:14:29 pm ---WOW that is one hideous "website."
--- End quote ---
Couldnt agree more! Sounds like an opertunity for me! But anyway, Id go for some glow wire or something.
pointdablame:
wow. that's pretty pricy stuff. And couple that with the fact that they want you to use a 150 watt metal halide bulb.... your cabinet is going to get HOT FAST!!!
EL wire is much cheaper, easier to use/cut/apply, uses a LOT less power, and creates almost no heat.
Personally, I still don't see any reason to use this other than the "hey I used fiber optics" factor. It's a good idea, but there are much better alternatives.
JDSkydiver:
I agree...
I'd think using a "neon-esque" flourescent list just under the lip of the CP might give a nice "ground effect" look.
But IMO, the Fiber optics might be a bit much...
But what do I know...?
JDSkydiver
shmokes:
I can't help dropping this website every time someone points out a bad website. This is the place where I ordered my T-molding. It was over a year ago and the website is still the same. Really awful. Your eyes will bleed.
Sorry for the hijack...kind of.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version