Main > Main Forum

Show me photos of your home-built 4-Player (Quad) Contol Panel!

<< < (19/20) > >>

nipsmg:


http://arcadia.gerety.net/


Sorry, Wish I had a better image. :-/

Timoe:
with a UAII would there be a large gap between the monitor bezel/glass and the back of your control panel if you didn't notch your CP top to go in there like that?

The reason I ask is I am planning on using that area, if there is an "area" for a small panel that will stay with the cabinet when I swap out panels.

Timoe:
see pic for area I'm talking about

toyfiend2004:

--- Quote from: johnnysmitch on June 29, 2005, 01:46:45 pm ---
--- Quote from: toyfiend2004 on June 28, 2005, 10:58:15 am ---what did you make your CP base out of?
--- End quote ---

--- End quote ---

nipsmg:

--- Quote from: timoe on June 29, 2005, 02:59:47 pm ---see pic for area I'm talking about

--- End quote ---

Timoe:

That notch was basically just for my panel design, and to save wood.  I didn't need the space that was notched out, so I notched it out.  If I cut that part off the control panel, there would be a large gap there...

I would not recommend taking that area away from the CP, however.  That part of the cp is the exact width of the cabinet, and rests on the "Lip" part that of the base that is designed to support to control panel.  My control panel sticks out a great deal farther than that lip.  Unless you use a really good method of securing your CP down, you're going to have trouble because a lot more of your CP will be overhanging the front of the cabinet frame and it'll be unstable.

I hope I expressed that clearly enough, It's 5:00PM, I'm about to leave work, and my brain is totally shot.

--NipsMG

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version